|
|
Seller assumes all responsibility for this listing.
A nice old drill press. The radial design allows the drilling head to travel in and out up to 18 inches on a smooth travelling ram. It also swivels 360 degrees around the column, tilts 45 degrees left or right and locks in any position. Spindle travel is 6 inches. It was built to handle either horizontal or vertical drilling operations. The drilling table is a massive 26" x 18" cast iron machined surface with 4 "T" slots and a trough for oil or drilling bits. Not the original motor. Single phase.
$600 or best offer.
EBAY listing -
http://www.ebay.com/itm/Walker-Turner-Radial-Arm-Drill-Press-massive-good-working-condition-/131553537726?ssPageName=ADME:L:LCA:US:1123 |
|
|
Seller assumes all responsibility for this listing.
|
Seller assumes all responsibility for this listing.
|
|
|