|
|
|
Seller assumes all responsibility for this listing.
Nice State B4 Oscillating Spindle sander
240 Volt 3 Phase
Flushed the gearbox and refilled it with the proper gear oil.
Installed a O-Ring in the origal oil sight glass to replace the paper gasket that tend to leak
Table tilt gear and trunnens are not damaged or worn and the table tilts locks as it should.
Table tilt scale is good and clean
Test ran it and used it for a bit. No oil leaks.
Runs real good. Smooth and quiet it is I think the smoothest running B4 i have heard.
It has a set of 9 spindles and all 3 throat plates are included.
Went over and serviced the starter and electrical. Newer long cord installed.
20” x 24” table 40” high 280 Lbs
Copy of manual included.
Will load for free and WILL SHIP |
|
|
|
Seller assumes all responsibility for this listing.
|
|
Seller assumes all responsibility for this listing.
|
|
|