|
|
Seller assumes all responsibility for this listing.
I have the J-140 mortiser complete. I will have to rig the hold-down method somehow but would be great if anyone had these spare parts. I have a wooden shim that's beveled which slides into the table center and not sure if that sacrificial piece is to control blow-out from rear of subject material chiseled but I think something else is supposed to go into that slot with hardware and clamps? Also the fork about that stays stationary and doesn't move with the motor/chisel. |
|
|
Seller assumes all responsibility for this listing.
|
Seller assumes all responsibility for this listing.
|
|
|